There are 282 products.
CAN Bus Controller Module, CANopen Slave, Isolated, -25 to 75C

CANopen slave module, CiA 301 v4.02
NXP SJA1000T controller, 16MHz clock
1 x isolated CAN bus port
Baud rate 10k - 1M
Isolation 3000VDC / 2500Vrms
Built-in 120 ohm terminal resistor
Hardware watchdog timer
PWR, Rx/Tx, ERR status LEDs
Consumption 2W
Dimensions 31 x 115 x 91 mm
-25/75C (special components required)
Storage -40 to 80C, 5-90% RH

375.20 €
Item numberCAN-BUS-CONTR-MODUL-3
On the way in
16-Channel DeviceNet Digital Output Module, Open Collector, DIN-Rail

16 x Digital Output (Sink)
Open Collector Output
Load Voltage +5-30VDC, 100mA/ch
DeviceNet interface, 1 port
Baud rate 125/250/500 kbps
Node ID 0-63
Terminal resistor switch 120 Ohm
Isolation 3750 Vrms
DIN-Rail mounting
+10-30VDC, 1.5W
-25~75C (special components required)
32.3 x 99 x 77.5 mm

210.38 €
Item number16-CHANN-DEVIC-DIGIT
On the way in
Programmable Device Server, 6-Port Serial to Ethernet, DI/DO, -25-75°C

80186-80MHz or compatible CPU
6 Serial Ports: RS-232 / RS-485
10/100Base-TX Ethernet, RJ-45
1x Digital Input, Dry Contact
2x Digital Output, Open Collector
Watchdog Timer
512KB Flash, 512KB SRAM, 16KB EEPROM
Baud Rate up to 115200 bps
DIN-Rail or Wall Mounting
+10-30VDC, 2.0W
72 x 35 x 123 mm
-25-75°C (special components required)

402.00 €
Item numberPROGR-DEVIC-SERVE-PORT-2
On the way in
DeviceNet Communication Controller with DIN-Rail Mount, -25 to 75°C

DeviceNet communication controller
NXP SJA1000T CAN controller, 16MHz
CPU 80186, 80MHz compatible
Baud rates 125k/250k/500k
Node ID range 0-63
Isolation 3000VDC / 2500Vrms
120 Ohm terminal resistor jumper
DIN-rail mounting
Watchdog IC, RTC included
10-30VDC power input
64 x 119 x 91 mm
-25-75C (special components required)

313.56 €
Item numberDEVIC-COMMU-CONTR-DIN
On the way in
Programmable Device Server with 10/100 Ethernet, 2x RS-232, RS-485, 4DI/4DO

CPU: 80186-80 MHz compatible
512KB Flash, 512KB SRAM, 16KB EEPROM
4x Digital Input (Dry Contact)
4x Digital Output (Open Collector)
10/100 Base-TX Ethernet RJ-45
2x RS-232, 1x RS-485 ports
Baud rate up to 115200 bps
Watchdog Timer
DIN-Rail or Wall mounting
10-30VDC power supply
72 x 35 x 123 mm (WxLxH)
-25~75°C (special req. components)

349.74 €
Item numberPROGR-DEVIC-SERVE-10
On the way in
Programmable Device Server with 6x DI, 7x DO, RS-232/485 & Ethernet

80186-80MHz CPU or compatible
6x Digital Input (Wet Contact)
7x Digital Output (Open Collector)
10/100 Base-TX Ethernet RJ-45
RS-232/RS-485 port, 115200bps
Bias resistor 1k Ohm
Node address up to 254
Watchdog timer
Metal casing, wall mount
10-30VDC power input, 2.0W
-25~75°C (special components required)
102 x 29 x 125 mm

253.26 €
Item numberPROGR-DEVIC-SERVE-6X
On the way in
Serial Device Server RS-232 to Ethernet, PoE, DIN-Rail, -25 to 75°C

32-bit ARM CPU
1 x RS-232 (5-wire), up to 115200bps
10/100 Base-TX RJ-45 with PoE
IEEE 802.3af PoE, Class 1
Auto-negotiating, Auto-MDI/MDIX
Metal casing, DIN-rail mount
-25 to +75°C operating temp
Humidity 10-90% RH, non-cond.
12-48VDC (terminal block) or PoE
75 x 24 x 83 mm

158.12 €
Item numberSERIA-DEVIC-SERVE-RS-6
On the way in
BACnet/IP to Modbus TCP Gateway, 32 Stations, DIN-Rail

Modbus TCP Client, up to 32 stations
BACnet objects: AI, AO, AV, BI, BO, BV
MSI, MSO, MSV supported
Converts 180 DI, DO, AI and AO points
BIBBs: DS-RP-B, DS-RPM-B, DS-WP-B
DS-WPM-B, DM-DDB-B, DM-DCC-B, DM-RD-B
1 x RJ-45, 10/100Base-TX
Metal casing, DIN-Rail mount
10-30VDC, 5W @ 24VDC
33 x 120 x 116 mm
-25 to 75C (special components required)
Humidity 10-90% RH, non-condensing

624.44 €
Item numberBACNE-IP-MODBU-TCP-2
On the way in
Serial Device Server with Ethernet, RS-232/485 and DI/DO

CPU 80186-80MHz compatible
10/100 Base-TX Ethernet RJ-45
3x Serial: RS-232, RS-485, RS-422
Baud rate up to 115200bps
4x Dry Contact Digital Input
4x Open Collector Digital Output
Watchdog Timer
Metal casing, wall mount
-25 to 75C (special components required)
+10-30VDC power input
102 x 29 x 125 mm

380.56 €
Item numberSERIA-DEVIC-SERVE-ETHER
On the way in
Programmable Device Server, 4x DI/4x DO, RS-232/485, 10/100 Ethernet

80186-80MHz compatible CPU
10/100Base-TX Ethernet RJ-45
2x RS-232, 1x 5-wire RS-232, 1x RS-485
4x Dry Contact Digital Input
4x Open Collector Digital Output
Baud rate up to 115200 bps
512KB Flash, 512KB SRAM, 16KB EEPROM
DIN-rail or wall mounting
+10-30VDC power input
72 x 35 x 123 mm (W x L x H)
-25 to +75C operating temp

356.44 €
Item numberPROGR-DEVIC-SERVE-4X-3
On the way in
Programmable Device Server with Ethernet, RS-232/485 and DIO

Ethernet 10/100 RJ-45 port
2x RS-232, 1x RS-485 serial
4x Dry Contact Digital Input
4x Open Collector Digital Output
Watchdog Timer
Metal casing, wall mounting
-25-75C (special components required)
10-30VDC power input
102 x 29 x 125 mm (W x L x H)

380.56 €
Item numberPROGR-DEVIC-SERVE-ETHER-2
On the way in
CANopen Gateway with Modbus RTU, RS-232/422/485, DIN-Rail

Modbus RTU to CAN/J1939 gateway
1 x RS-232, RS-422, RS-485 ports
Baud rates up to 115200 bps
CAN port 250k baud, ISO-11898-2
CAN 2.0A/2.0B compliant
3000VDC isolation, 2500Vrms optocoupler
120 ohm terminal resistor jumper
DIN-rail mounting
Power consumption 1.5W
108 x 72 x 35 mm
-25 to +75C operating temp
10-90% RH non-condensing

494.46 €
Item numberCANOP-GATEW-MODBU-RTU
On the way in
HART Gateway with RS-232, 1-Port, Ethernet 10/100Base-TX

1x RS-232 HART port (3-wire)
10/100Base-TX Ethernet, Auto-MDIX
Supports 2-wire or 4-wire HART devices
Point-to-Point or Multi-Drop topology
Up to 15 HART devices
Short and Long Frame support
Burst mode supported
250 Ohm loop resistor via jumper
Isolation per UL1577
DIN-Rail or wall mounting
10-30VDC input, 1W consumption
72 x 35 x 121 mm

564.14 €
Item numberHART-GATEW-RS-232
On the way in
Programmable Device Server, 4x DI/4x DO, RS-232/485, 10/100 Ethernet

80186-80 MHz CPU or compatible
10/100 Base-TX Ethernet port
3x RS-232, 1x RS-485 Ports
4x Dry Contact Digital Input
4x Open Collector Output (NPN)
512KB Flash, 512KB SRAM, 16KB EEPROM
Watchdog Timer
Metal Casing, Wall Mounting
10 - 30VDC Power Input
102 x 29 x 125 mm (WxLxH)
-25-75C (special components required)

387.26 €
Item numberPROGR-DEVIC-SERVE-4X-4
On the way in
CAN Bus Controller Module, 1-Port, NXP SJA1000T, Isolated

CAN bus communication module, 1 port
NXP SJA1000T controller, 16 MHz clock
CiA 301 v4.02 protocol, NMT Master
Baud rate 10 kbps to 1 Mbps
Isolation 3000 VDC / 2500 Vrms
Built-in 120 ohm terminal resistor
CPU 80186, 80 MHz compatible
EEPROM 16KB, Flash 512KB, SRAM 512KB
Hardware watchdog timer
Consumption 2W
Dimensions 31 x 115 x 91 mm
-25-75C (special components required)

375.20 €
Item numberCAN-BUS-CONTR-MODUL-2
On the way in
3G/4G Gateway with GPS, RS-232/485, CAN Bus and Ethernet

ARM CPU processor
LTE FDD B1/B3/B5/B7/B8/B20
DC-HSPA+ up to 42 Mbps downlink
GPS/GNSS NMEA 0183, 32 channels
1 x RJ-45 10/100Base-T(X)
2 x RS-232, 1 x RS-485 isolated
CAN Bus interface
SD card slot, max 32GB SDHC
Watchdog timer
Metal casing, DIN-rail mount
-25 to +75C (special components required)
24VDC, 4.8W consumption

979.54 €
Item number3G-4G-GATEW-GPS-3
On the way in
M-Bus Master/Slave Converter, DIN-Rail, -25 to 75°C

1 Master Port, 1 Slave Port
Auto-adjust Baud Rate
Isolation 3750 Vrms photo-couple
Short-circuit Protection
DIN-Rail Installation
Consumption 1.6-9.7W @ 24VDC
Storage Temp -30 to 80°C
Humidity 10-90% RH non-condensing
-25-75°C (special components required)
Supply: 24VDC
Dimensions: 25 x 116 x 120 mm

257.28 €
Item numberBUS-MASTE-SLAVE-CONVE
On the way in
Serial Device Server with 4x RS-232, 1x RS-485, PoE, 10/100 Ethernet

CPU 80186-80MHz or compatible
10/100 Base-TX RJ-45 Ethernet
4 x RS-232, 1 x RS-485 ports
PoE IEEE 802.3af Class 1
Baud rate up to 115200 bps
Bias resistor 1 kOhm
Node address up to 254
Watchdog timer
Metal casing, wall mounting
-25-75C (special components required)
12-48VDC, 2.9W
88 x 28 x 123 mm

459.62 €
Item numberSERIA-DEVIC-SERVE-4X-2
On the way in
1-Port CAN Bus Controller Module, NXP SJA1000T, Isolated

NXP SJA1000T controller, 16 MHz clock
1 x CAN bus port
Baud rate 125k/250k/500k
Isolation 3000 VDC / 2500 Vrms
Switchable 120 ohm terminal resistor
Supports DeviceNet, CAN 2.0A/2.0B
ISO-11898-2 compliant
Watchdog timer built-in
Status LEDs: NS, RUN, MS
Power consumption 2W
Operating temp -25 to +75C
Dimensions 31 x 115 x 91 mm

364.48 €
Item numberPORT-CAN-BUS-CONTR
On the way in
1-Port RS-485/422 to Ethernet Gateway, DIN-Rail -25~75°C

32-bit ARM CPU
1 x RS-485/422 serial port
10/100 Base-TX Ethernet RJ-45
Auto-MDIX, auto-negotiating
Baud rate up to 115200 bps
Bias resistor 1 kOhm
Parity: None/Odd/Even/Mark/Space
Max 254 node addresses
DIN-rail mount, plastic casing
+12-48VDC, 0.07A @ 24VDC
-25-75°C (special components required)
52 x 27 x 95 mm

166.16 €
Item numberPORT-RS-485-422
On the way in
Showing 181-200 of 282 item(s)