Item number HART-GATEW-RS-232

HART Gateway with RS-232, 1-Port, Ethernet 10/100Base-TX

1x RS-232 HART port (3-wire)
10/100Base-TX Ethernet, Auto-MDIX
Supports 2-wire or 4-wire HART devices
Point-to-Point or Multi-Drop topology
Up to 15 HART devices
Short and Long Frame support
Burst mode supported
250 Ohm loop resistor via jumper
Isolation per UL1577
DIN-Rail or wall mounting
10-30VDC input, 1W consumption
72 x 35 x 121 mm

564.14 €
Excl. VAT
Quantity
On the way in
file_download DOWNLOADS

Specifications

Data Only Digital Data
Installation DIN-Rail or Wall Mounting
Isolation UL1577 Spec.
Operating Temperature 40 ~ +75 °C
Ports 1RS-232(3 wires)10/100Base-TX Ethernet Controller (Auto-negotiating, Auto_MDIX)
Input Range Unregulated +10 ~ +30 VDC
Consumption 1 W
Dimensions (mm) 72 x 35 x 121 (W x L x H) Detail
Storage Temperature 40 ~ +80 °C
Humidity 5% ~ 95% RH, Non-condensing
Reverse Polarity Protection Power reverse polarity protection, Over-voltage brown-out protection
Protocol 2-pin screwed terminal block
Device 2-wired or 4-wired HART devices
Topology Point to Point or Multi-Drop
Frame Type Short and Long Frame
Burst Mode Supported
Max. HART Device 15
Loop Resistor 250 Ω resistor by Jumper

HART Gateway

This HART Gateway connects HART instruments to Ethernet-based systems, enabling communication with both 2-wire and 4-wire HART devices through a single RS-232 interface. It is typically used in process plants where digital HART data needs to be integrated into higher-level control and monitoring systems.


1x RS-232 HART port · 10/100Base-TX Ethernet · Up to 15 HART devices · DIN-Rail mounting


Features that make the difference

  • Dual HART support -works with both 2-wire and 4-wire HART instruments
  • Flexible topology -supports Point-to-Point and Multi-Drop setups
  • Burst mode -enables faster data updates from connected devices
  • Robust protection -built-in reverse polarity and over-voltage protection
  • Isolated design -UL1577 isolation for stable, safe operation


Application areas

The gateway suits industrial environments where HART instruments need to be connected to an Ethernet network for remote monitoring and configuration.

  • Process industry and plant monitoring
  • Integrating HART instruments into SCADA systems
  • Remote configuration of field instruments
  • DIN-Rail installations in cabinets and panels


A reliable and flexible solution for bringing HART data into modern Ethernet networks.