General Information About RAID

Since the introduction of the RAID concept in 1987, numerous data storage methods have been developed and standardized, known as RAID levels. This section describes the applications, advantages, and disadvantages of commonly used RAID levels.

Hardware RAID vs. Software RAID

This section is intended for guidance only.

RAID (Redundant Array of Independent Disks) uses multiple independent hard drives to create one or more arrays, providing increased capacity, improved performance, and enhanced data security.

RAID Hardware

Advantages:

Hardware RAID uses a dedicated RAID controller installed in a server or PC. Modern systems typically use PCI Express controllers. The controller manages disk operations and RAID configuration without burdening the CPU and is operating-system independent. This ensures maximum read/write performance, lower system load, and easy replacement of failed drives.

Disadvantages:

Requires additional hardware space. In case of controller failure, an identical controller model is required to recover data. Hardware RAID solutions are generally more expensive.

RAID Software

Advantages:

Software RAID is integrated into the operating system and does not require additional hardware. It is easy to implement, cost-effective, and suitable for systems without expansion capabilities.

Disadvantages:

Typically slower than hardware RAID and places additional load on the CPU. Often OS-dependent and does not support multi-OS disk sharing. Replacing failed drives is more complex.

RAID 0

RAID 0 (striping) distributes data across multiple drives for high performance but offers no redundancy and increased risk of data loss.

RAID 1

RAID 1 mirrors data across two drives, providing excellent data protection at the cost of 50% capacity loss.

RAID 5

RAID 5 distributes data and parity across all drives and can tolerate one drive failure. It offers a good balance of performance and data protection.

RAID 10

RAID 10 combines RAID 0 and RAID 1, delivering high performance and strong redundancy. Requires a minimum of four drives.

RAID 6

RAID 6 uses dual parity and can tolerate two simultaneous drive failures. Requires a minimum of four drives.

JBOD (Just a Bunch Of Disks)

JBOD is not a RAID level. Drives operate independently without redundancy or performance enhancement.