18 - 36VDC DC / DC converter for 12VDC
Large DC voltage DC / DC converter for 12VDC 800mA (9.6Watt)
60.57 €
Item numberDC-DC12DIN
18 - 36VDC DC / DC converter for 12VDC
Large DC voltage DC / DC converter for 12VDC 800mA (9.6Watt)
32-bit ARM CPU
RS-485/422 port, isolated
RJ45 10/100 with PoE 802.3af
Baud rate up to 115200bps
Bias resistor 1 kOhm
Node address up to 254
DIN-rail mounting
12-48VDC or PoE powered
52 x 27 x 95 mm
-25-75°C (special components required)
6 x RTD input channels
Sensors: Pt100, Pt1000, Ni120, Cu50/100/1000
16-bit resolution, +-0.05% FSR accuracy
Sampling rate 12 Hz total
Resistance measurement 3.2 kOhm max
1 x RS-485, DCON protocol
Baud rate 1200-115200 bps
Open wire detection
Overvoltage protection 120VDC
10-95% RH non-condensing
10-30VDC, 1.1W
72 x 123 x 35 mm
I-87K series I/O expansion unit
4 expansion slots
USB Type B connector, 3000VDC isolation
Auto configuration via DIP switch
Status LEDs: Power, System, Auto-Config
DIN-Rail or wall mounting
Storage temp -30 to +80C
Humidity 10-90% RH, non-condensing
10-30VDC, 2.0W consumption
188 x 132 x 111 mm
-25 - +75C (special components required)
Serial-to-Ethernet device server
80186-80MHz compatible CPU
5x RS-232, 1x RS-485 ports
10/100 Base-TX Ethernet port
Baud rate up to 115200 bps
1x DI, 2x Open Collector DO
Built-in watchdog timer
Max 254 node address
Metal casing, wall mount
+10-30VDC power input
102 x 29 x 125 mm (WxLxH)
-25~75°C (special components required)
Modbus TCP & RTU, MQTT, SNMP support
32-bit ARM CPU 1.0 GHz
XV-board I/O expansion slot
Built-in 4GB microSD (up to 32GB)
1x RJ-45 10/100/1000 Base-TX
COM2 RS-232, COM3/4 RS-485
DIN-rail or wall mounting
-25~75°C (special components required)
12-48VDC input, 4.8W
117 x 126 x 58 mm
Profibus DP-V0/V1 protocol support
10/100Base-TX Ethernet, Auto-MDIX
RS-232 firmware/config port
Profibus baud rate up to 12 Mbps
Isolation 3000VDC / 2500Vrms
CPU 80186, 80MHz compatible
PWR, RUN, ERR status LEDs
DIN-Rail mounting
Power consumption 2.5W
Dimensions 72 x 33 x 119 mm
-25~75C (special components required)
32-bit ARM CPU 1 GHz
Modbus TCP/RTU for SCADA software
MQTT Client, SNMP, FTP, DDNS
IF-THEN-ELSE logic, unlimited rules
Data logger, timer, schedule operation
Power data display and PUE setting
2 x RJ-45 10/100/1000 Base-TX
1 x RS-232, 2 x RS-485 isolated
microSD socket, 4GB card included
DIN-Rail mounting
12-48VDC, 4.8W
35 x 167 x 119 mm
PROFIBUS DP Gateway (DP-V0 protocol)
RS-232/RS-422/RS-485 serial port
Siemens SPC3 PROFIBUS controller
ADI ADM2486 isolated transceiver
PROFIBUS baud rate up to 12 Mbps
Serial baud rate up to 115200 bps
Isolation 3000VDC / 2500Vrms
Metal casing, DIN-rail mount
96 x 33 x 119 mm (W x L x H)
-25 to +75C operating temp
Power consumption: 2.5W
EtherCAT Master PAC
2 x RJ-45 EtherCAT ports (1 IN, 1 OUT)
Node ID up to 256
Max. 100m between stations (100BASE-TX)
CAT5 shielded Ethernet/EtherCAT cable
EFT 1KV, ESD 4KV, Surge 1KV protection
Plastic casing
DIN-Rail or wall mounting
24VDC, 2W max consumption
25 x 108 x 93 mm (W x L x D)
-25 to +75C operating (special components required)
10-90% RH non-condensing
80186-80MHz compatible CPU
10/100Base-TX Ethernet RJ-45
1 x RS-232, RS-485 serial port
115200bps max baud rate
Up to 254 node addresses
Built-in watchdog timer
Metal casing, wall mounting
5-90% RH non-condensing
2.0W power consumption
-25-75°C (special components required)
+10-30VDC power supply
102 x 29 x 125 mm (WxLxH)
USB I/O expansion unit
I-87K series I/O modules
2 expansion slots
Isolated USB Type B, 3000VDC
1-bit DIP auto configuration
Power/System/Config LEDs
DIN-Rail or wall mounting
Humidity 10-90% RH non-cond.
Storage -30 to +80C
10-30VDC, 1.0W
-25 to +75C (special components required)
95 x 132 x 111 mm
32-bit RISC CPU
2.8in TFT LCD, 240 x 320, 65535 colors
Resistive touch panel
1 x RS-485 with Self-Tuner
Buzzer, rotary switch, reset button
Backlight life 20,000 hours
Brightness 160 cd/m2
IP40 front panel, wall mounting
12-48VDC, 1.5W
127 x 92 x 31 mm
20 to 70C operating temperature
10-90% RH non-condensing
EtherCAT Master PAC
2x encoder channel (0-1)
Max. 48 bit position resolution
SSI mode / BiSS-C mode
Simultaneous sampling
Distributed Clocks support
Cycle time 100 us
Photo-isolation 2000 VDC
+24VDC input, max. 4.5W
-25 to 75C (special components required)
17.5 x 108 x 90 mm
DIN-Rail or wall mounting
CPU 80186-80MHz or compatible
4x RS-232, 1x RS-485 ports
10/100 Base-TX Ethernet RJ-45
Baud rate up to 115200 bps
16KB EEPROM, 512KB Flash, 512KB SRAM
Watchdog timer included
Metal casing, wall mounting
-25-75°C (special components required)
10-30VDC power input
102 x 29 x 125 mm
CPU 80186-80MHz compatible
10/100Base-TX Ethernet RJ-45
3x RS-232, 1x RS-485 ports
Baud rate up to 115200bps
16KB EEPROM, 512KB Flash
512KB SRAM, watchdog timer
Metal casing, wall mounting
-25-75C (special components required)
+10-30VDC power input
102 x 29 x 125 mm (W x L x H)
8-channel RTD input, 2/3-wire
Pt100/1000, Ni120, Cu100/1000, JPt100
16-bit resolution, +/-0.05% FSR
CANopen CiA301/401 protocol
Baud rate 10kbps - 1Mbps
Isolation 3000VDC / 3000Vrms
Open wire detection
Built-in 120 ohm terminal resistor
DIN-rail mounting, 1.5W consumption
Dimensions: 33 x 99 x 78 mm
-25~75C (special components required)
Storage -30~80C, 10-90% RH
5 x RJ-45 10/100Base-TX ports
IEEE 802.3, 802.3u, 802.3x
Store and forward switching
MAC table 2048 entries
Frame buffer 768 Kbit
Flow control and back pressure
1500 Vrms isolation, 1 minute
Reverse polarity protection
DIN-Rail mounting, plastic casing
12-53VDC, 0.1A @ 24VDC
76 x 118 x 38 mm
-40 to 75C (special components required)
5 x RJ-45 10/100Base-TX ports
IEEE 802.3, 802.3u, 802.3x
Store and forward wire speed switching
MAC table 1024, 256 Kbit buffer
1.4 Gbps memory bandwidth
IP67 rated, IP66 at wide temp range
Reverse polarity protection
1500 Vrms isolation, 1 kV DC isolated
Wall mounting, plastic casing
-40 to 75C (special components required)
10-30VDC, 0.12A @ 24VDC
85 x 137 x 76 mm
3-Channel Strain Gauge Input
16-bit Resolution, 1kHz Sampling
Range +-10V to +-25mV, SW Select
Full-Bridge Wiring
Accuracy +-0.1% FSR
Overvoltage Protection +-35VDC
2 x RJ-45 EtherCAT Ports
Cycle Time 1ms
DIN-Rail Mount, Plastic Casing
Input Range +10 to +30VDC
-25-75C (special components required)
33 x 127 x 108 mm