Item number ETHER-MODUL-4X-DI-2

Ethernet I/O Module with 4x DI, 4x DO, RS-232/485 and PoE

4 x Digital Input, Dry Contact
4 x Digital Output, Open Collector
10/100 Base-TX RJ45 Ethernet
2 x RS-232, 1 x RS-485
PoE IEEE 802.3af Class 1
Watchdog Timer
Metal Casing, Wall Mounting
12-48VDC via Terminal Block
102 x 29 x 125 mm
-25/+75C (special components required)

426.12 €
Excl. VAT
Quantity
On the way in
file_download DOWNLOADS

Specifications

CPU 80186-80 MHz or compatible
Flash 512 KB ; Erase unit is one sector (64 KB) ;100,000 erase/write cycles
Installation Wall mounting
Type Open CollectorDry Contact
Operating Temperature -25 ~ +75 °C
Watchdog Timer Yes
Status 1 x Power/PoE5 x digit 7 Segment
Ports 10/100 Base-TX, RJ-45 port (Auto-negotiating, auto MDI/MDI-X, LED indicator)2 x 5-wire RS-2321 x RS-485
Consumption 2.9 W
Dimensions (mm) 102 mm x 29 mm x 125 mm (W x L x H)
Storage Temperature -40 ~ +80 °C
Humidity 5 ~ 90% RH, Non-condensing
Channels 4
Powered from Terminal Block +12 ~ 48 VDC
Sink/Source (NPN/PNP) Sink (NPN)Source, Common Ground
ON Voltage Level +3.5 ~ +30 V
OFF Voltage Level +1 V max.
Load Voltage 30 VDC, max.
Load Current 100 mA, max.
Baud Rate 115200 bps Max.
Parity None, Even, Odd, Mark, SpaceNone parity is required when using 8 data bits and 2 stop bits on COM1/COM2.
Data Bit 7, 8: for COM1 and COM25, 6, 7, 8: for COM3
Stop Bit 1, 2: for COM1 ~ COM3
Casing Metal
Powered from PoE IEEE 802.3af, Class 1
EEPROM 16 KB; Data retention: 40 years; 1,000,000 erase/write cycles.
SRAM 512 KB
Bias Resistor Yes, 1 KΩ
Node Address 254 (max.)

Ethernet I/O Module

This Ethernet I/O Module combines digital input and output channels with serial communication ports, allowing industrial controllers to monitor and control equipment over a standard network connection. It is designed for continuous operation in demanding industrial environments and can be powered directly through the Ethernet cable.


4x Digital Input · 4x Digital Output · RS-232/RS-485 · PoE 802.3af


Built-in Functions for Industrial Control

  • Dry Contact Inputs - reads 4 digital signals from switches or sensors
  • Open Collector Outputs - drives 4 relays, valves or indicator lamps
  • Dual RS-232 and RS-485 Ports - connects legacy serial equipment to the network
  • Power over Ethernet - runs from PoE or a 12-48VDC terminal block
  • Wide Temperature Range - operates reliably from -25C to +75C


Where the Module Fits In

The module is well suited for industrial automation, building management and remote monitoring, wherever digital I/O and serial devices must be linked to an Ethernet network.

  • Factory floor monitoring
  • Building automation systems
  • Remote equipment control
  • SCADA and PLC integration


A robust way to combine digital I/O and serial communication over a single Ethernet connection.