There are 181 products.
Opto-Isolated Digital I/O Module: 4 Inputs, 8 Outputs, RS485

8 digital outputs and 4 digital inputs
Open Collector Output
Photocouple Isolation
Digital input channels can be used as 16-bit counters
Configurable Power-on Value settings
Configurable settings for sure value
3750 Vrms insulation voltage
Dual Watchdog
Wide operating temperature range: -25 to + 75 ° C

171.12 €
Item numberM485-DIO4-I
Physically in stock
ICP DAS I-7550E is a PROFIBUS DP Master for Ethernet Slave devices Gateway

Gateway from Ethernet slave to PROFIBUS master
protocol / hierarchy: DP-V0 Slave
PROFIBUS Speed ​​(Kbps) in 10 step from 9.6 - 12000
speed setting is automatic
Max. Input data length: 240 byte
Max. Output data length: 240 bytes
Address setting: 0 ~ 126 Set by DIP switch or EEPROM
Ethernet protocol: TCP / UDP server / client
Configuration: Web Configuration

657.40 €
Item numberM485-PROFI-ETH-I
On the way in
ICPDAS I-7570 is a serial for HART converter. RS232 / RS422 or RS484 bus

Serial to HART Convert
Allows 2 pcs. Hart Masters
Point-to-Point or Multi-Drop Hart Mode
Possibility of connecting 15 HART modules
Point-to-point or multi-drop HART mode
for configuration of modules
Isolated COM 1: RS-232 / 422/485
PWR / RUN / ERR INDICATION LED
Built-in Watchdog
4 kV ESD protection

527.69 €
Item numberM485-HART-I
Physically in stock
M485 Profibus til HART Gateway konverterforKonverter / Forstærker

PROFIBUS TO HART Convert, Gateway
4 x HART Canals
Max. 2 pcs. HART Masters
Point-to-Point or Multi-Drop HART Mode
Possibility of connecting 15 HART modules
PWR / RUN / ERR indication LED
Built-in Watchdog
4 kV ESD Protection
Operating temperature -25-75 ℃
for DIN rail mounting

872.88 €
Item numberM485-PROFI-HART
On the way in
ICP DAS I-7024R-G is a 4 x analog output module, 0 - +/- 10V and 0 - 20mA, 14bit. 5 x digital input with DRY - Contact

RS485 module with volt / mA output. Digital input
4 x analog output - 0 - +/- 10V and 0-20mA
Resolution: 14bit
5 x Digital input - Active high on contact for frame
RS485 Bus - Module is Slave
Format: (N, 8, 1) (N, 8, 2) (E, 8, 1) (O, 8, 1)
Baud Rate: 1200 ~ 115200 bps
Supply: 10 ~ 30 VDC

415.27 €
Item numberM485-DA4DI5-1
Physically in stock
ICPDAS ANT-8 is a 9 dBi 2.4GHz Omni fiberant for mast mounting with N female and 1 meter cable N-female and RPSMA male

2.4GHz Omni directional antenna - dipole
for pipe montage
N-female connector
1 meter RG58 Coax cable
1 pc. RSMA - Male included
Weight: 1.4KG
Length: 45 cm
Diameter: 35mm

189.61 €
Item numberM485-ANT1+I
Physically in stock
ICPDAS WISE-7118ZL is a controller with 10 x analog input and 6 x digital output. Also for thermocoupler

Intelligent Controller with Web Server
Logical functions, such as: IF-THEN-ELSE
No programming. Just select, click and finish
Supporter: I/O module, counter, hour, e-mail
Modbus / TCP protocol for SCADA software Seamless integration
IEEE 802.3af compatible power over Ethernet ( Poe)
1 x RJ45 - 100Mbit Ethernet
7 x Analog input: 0 - +/-2.5V, 0 - 20mA (ext. Resistors)
A/I Resolution: 16bit
10 Samples per Second
A/I Also to Thermocouller: J, K, T, E, R, S, B, B, C, L, M, LDIN43710
6 x Digital Output: 0 - + 50VDC / 700mA Open Collector
Supply voltage: POE or 12 - 48VDC / 4.5Watt

444.48 €
Item numberL-CON10TC6O
On the way in
ICPDAS I-7015 is a module for 6 x temperature sensors 2-3 Wire, PT100, PT1000, NI120, CU50 / 100/1000. RS485.

RS485 module for 6 Temperature sensors
6-channel RTD input
3-wire RTD input with elimination of wire resistance
Resolution: 16-bit
Individual channel configuration
Disconnected sensor detection
Double Watchdog
Supply: 10 - 30vdc
Operating temperature: -25 to + 75 ° C

465.11 €
Item numberM485-ADRTD6-I
On the way in
L-CON Controller with 7 x Temperature sensor input, 2/3 wire Pt100, Pt1000, Ni120, CU100, Cu1000

Intelligent Controller with Webserver
Logical functions such as: IF-THEN-ELSE
No programming. Just pick, click and finished
Supports: I / O module, counter, timer, email
Modbus / TCP protocol to SCADA software seamless integration
IEEE 802.3af compliant Power over Ethernet ( PoE)
1 x RJ45 - 10 / 100Mbit Ethernet
7 x Temperature sensor inputs (differential)
2/3-wire Pt100, Pt1000, Ni120, CU100, Cu1000
A/I resolution: 16bit
12 samples per second (Total)
Individual sensor configuration
Power supply: PoE or 12 - 48VDC / 4.5Watt

448.23 €
Item numberL-CON7RTD
Physically in stock
ICPDAS I-7065 Relay box with 5 x relay closing contact - 4 x digital inputs. RS485 bus

RS485 I/O module with 4 digital inputs and 5 relay outputs

4 x Digital input (wet) active with voltage in

Digital input as 16 bit counter - 100Hz

5 x Relay output - COM, NO

Supply: 10 - 30VDC

YOUR

162.01 €
Item numberM485-REL5-I
Physically in stock
Cable with 2 x DB100 Han, 3M

3,0 meter kabel til brug mellem I/O-kort og TERM100S

235.97 €
Item numberKS-DB100MM-MM3
Physically in stock
Cable with 2 x DB100 Han, 5m

5,0 meter kabel til brug mellem I/O-kort og TERM100S

279.66 €
Item numberKS-DB100MM-MM5
Physically in stock
SCSI cable Cable with 2 x DB100 male, 1 meter

1 meter kabel til brug mellem I/O-kort og TERM100S

168.44 €
Item numberKS-DB100MM-MM
Physically in stock
Ethernet based module with MODBUS TCP/IP with 2 x digital input 2 x power relay

Ethernet I/O module Modbus/TCP / UDP slave
1 x RJ45 Ethernet
Redundant Power Supply
Protocol: TCP, UDP, HTTP, DHCP, BOOTP and TFTP
Web configuration and firmware update via Ethernet
2 x digital input (Wet - volts supplied)
2 x Relay, COM, NO - 250VAC 5A, 30VDC 5A
Avoid inductive load to relay contacts
With locked DI and 32-bit 3.5kHz counter
With I/O pair - input is mirrored in the other's output
Dual-watchdog with Power-on-safe value
Supply voltage: 12 - 48VDC, 1.7 Watt
Dimensions: 98 x 52 x 27 mm
Operating temperature: -25 - +75°C

129.31 €
Item numberETH-MOD2I2R-I
Physically in stock
ICP DAS I-7080 is a 2 channel frequency counter module with 2 inputs, max. 100kHz. 32 bits count. 2 x digital output.

RS485 Frequency counter with 2 digital outputs
2 x counter entrance Max. 100kHz
input is Wet / Sink - Max + 30volt
32 bit counter - count up
for frequency and pulses
2 X Digital Output - Open Collector (OC)
Max. OC voltage: 30VDC / 30MA
Supply voltage: 10 - 30VDC
Dim: 123 x 72 x 35 mm
Operating temperature: -25 - + 75 ° C

217.75 €
Item numberM485-COUNT-I
On the way in
ICPDAS ET2-6064D is a web-based relay module with 24 relay output. 18 x Power Relay 250VAC / 5A

Ethernet-based relay module with Modbus
with I/O Pair Function
Digital signals are mirrored on another module outputs
Power Relay, 250vac, 30vdc, 5A
DINr
Supply voltage: 10 - 30vdc, 3 watts
Dim: 180 x 111 x 70 mm
Operating temperature: -25 - +75°C

562.53 €
Item numberETH-MOD24
Physically in stock
Modbus I/O Module with 8 x Digital Input Wet / Dry, 8 x Digital Output, with P2P

Modbus / TCP I / O module with built-in Web server
Modbus / TCP and Modbus / UDP protocols
2 x RJ45 Ethernet switch to Daisy-Chain topology
Dual Watchdog
Operating temperature range: - 25 to + 75 ° C
I / O Pair connection - Ingang refles in the second's exit
8 x Digital input: Wet (Apply Volt), Dry (Contact) - Digital Input: 0 - + 50CDC or Open / GND
8 x Digital Outout, Open Collector 0 - 40VDC / 650MA
Dimensions: 76 mm x 120 mm x 38 mm
Supply voltage: 12 - 48vdc, 4 watt
your bracket Wall mounting

399.59 €
Item numberETH-MOD8I8O
On the way in
ICPDAS tPET-P2R2 is a module with 2 x digital input (wet), 2 x power relay output Ethernet, 32bit counter. PoE

Ethernet I/O module Modbus/TCP / UDP slave

1 x RJ45 Ethernet

Power supply: PoE or 12 - 48VDC

Protocol: TCP, UDP, HTTP, DHCP, BOOTP and TFTP

Web configuration and firmware update via Ethernet

2 x digital input (Wet - volt supplied)

2 x Relay, COM, NO - 250VAC 5A, 30VDC 5A

Avoid inductive load on relay contacts

With locked DI and 32-bit 3.5kHz counter

With I/O pair - input is mirrored in the other's output

Dual watchdog with Power-on-safe value

Power: 1.7 Watts

Dimensions: 98 x 52 x 27 mm

Operating temperature: -25 - +75°C

142.44 €
Item numberETH-MOD2I2R-P-I
On the way in
Showing 81-100 of 181 item(s)