Item number HART-RS-232-422

HART to RS-232/422/485 Gateway, Modbus RTU/ASCII, 1 Port

1 x HART port, 2 or 4-wired devices
RS-232 (3-wire) / RS-422 / RS-485
Modbus RTU / Modbus ASCII protocol
Point to Point or Multi-Drop topology
Max. 15 HART devices, Burst Mode support
Loop power output +30V
Loop resistor 250 Ohm (1W) via DIP-switch
Isolation per UL1577 spec
Reverse polarity and brown-out protection
10-30VDC, 3.5W max
25 x 116 x 120 mm, DIN-Rail
-25 to +75C (special components required)

471.68 €
Excl. VAT
Quantity
On the way in
file_download DOWNLOADS

Specifications

Data Only Digital Data
Installation DIN-Rail
Isolation UL1577 Spec.
Operating Temperature 25 ~ +75 °C
Ports 1RS-232(3 wires) / RS-422 / RS-485
Input Range Unregulated +10 ~ +30 VDC
Consumption 3.5W (Max.)
Dimensions (mm) 25 x 116 x 120 (W x L x H)
Storage Temperature 30 ~ +80 °C
Humidity 10% ~ 90% RH, non-condensing
Reverse Polarity Protection Power reverse polarity protection, Over-voltage brown-out protection
Baud Rate 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200
Protocol 2-pin screwed terminal blockModbus RTU / Modbus ASCII
Device 2-wired or 4-wired HART devices
Topology Point to Point or Multi-Drop
Frame Type Short and Long Frame
Burst Mode Supported
Max. HART Device 15
Loop Resistor 250 Ω (1W) by Dip-Switch
Loop Power Yes (module provides +30V output)

HART Gateway

This HART Gateway converts HART signals to Modbus RTU or Modbus ASCII over RS-232, RS-422 or RS-485. It is used to integrate 2-wired or 4-wired HART instruments into industrial monitoring and control systems.


Modbus RTU/ASCII · Up to 15 HART devices · Built-in loop power · DIN-Rail mounting


Features that make the difference

  • Flexible topology -supports both Point to Point and Multi-Drop
  • Built-in loop power -provides +30V directly from the module
  • Galvanic isolation -protects equipment per UL1577
  • Robust protection -against reverse polarity and over/under voltage
  • Wide temperature range -reliable operation from -25°C to +75°C


Application areas

The gateway is suited for industrial environments where HART instruments need to communicate with a higher-level Modbus system.

  • Process industry and automation
  • Field instrumentation using the HART protocol
  • Integration of analog meters into SCADA systems
  • Monitoring of 2-wired or 4-wired transmitters


A reliable and isolated solution for bringing HART data into Modbus-based systems.