Item number ETH-DI6W-POE

PoE Ethernet I/O Module with Modbus TCP and MQTT. 6 x Digital Input, Power over Ethernet

PoE Ethernet I/O module
6 x digital input (Wet)
Sink/Source (NPN/PNP)
32-bit counter, 3.5 kHz
Modbus TCP, Modbus UDP, MQTT
1 x RJ45 10/100 with PoE
3750 Vrms isolation
Overvoltage protection +70VDC
LED for Run, Ethernet, PoE
DIN-rail mounting
PoE or 12 - 48VDC
-25 - +75°C

127.30 €
Excl. VAT
Quantity
On the way in
file_download DOWNLOADS

Specifications

Operating Temp. -25 to +75°C
Andet 32-bit counter 3.5 kHz, overvoltage protection +70VDC, status LEDs for Run, Ethernet and PoE
Forsyning PoE or 12 - 48VDC
Interface 1 x RJ-45, 10/100 Base-TX with PoE
Isolation 3750 VRMS
Montering DIN-Rail
Protokol Modbus TCP, Modbus UDP, MQTT
Indgange 6 x digital input, wet contact, sink/source (NPN/PNP)

PoE Ethernet I/O Module with Power in the Network Cable

An Ethernet I/O module with Power over Ethernet for six digital signals. It draws both data and supply through the network cable, so no separate power run is needed out to the measuring point.


Power over Ethernet · 6 digital inputs · 32-bit counter · Modbus TCP and MQTT


One Cable for Both Data and Power

  • PoE supply -saves a power supply and a cable run per measuring point
  • Alternative supply -also runs on 12 to 48 VDC where PoE is unavailable
  • Clear status -separate LEDs for Run, Ethernet and PoE make fault finding quick
  • Dual function -each input works as an on/off input and a 32-bit counter
  • Open protocols -Modbus TCP, Modbus UDP and MQTT


Suited Where Power Is Expensive to Run

Particularly relevant at measuring points far from the cabinet or in ceiling installations.

  • Building automation and access control
  • Scattered measuring points in large halls
  • Retrofitting into existing installations
  • Machine monitoring without local power


When a network cable has to be run anyway, PoE makes the rest of the installation simpler.