Sensorer og detektorer

Sensorer og detektorer

Teracom Sensorer og detektorer

Sensorer og detektorer er en vigtig komponent i ethvert system til fjernovervågning og kontrol. Sensorerne og detektorerne omdanner miljøparametre, så som temperatur, fugt, tryk etc. til elektriske signaler. Disse signaler overvåges af enheder, så som Ethernet-fjernovervågning eller GSM-fjernovervågning.

Sensorerne kommunikerer med controllere til fjernovervågning via en digital grænseflade. Interfacet kan enten være 1-Wire eller RS485.

1-Wire-grænsefladen er patenteret af Maxim Integrated Company. 1-Wire sensorer har eget ID og flere kan forbindes til samme bus. I dette tilfælde kan flere parametre overvåges af en enkelt controller. 1-Wire-grænsefladen er designet til at fungere over korte afstande, er den meget populær til hjemme- og kontorautomatisering.

Sensorer med RS485 tillader også at der er flere sensorer bå samme bus. En RS485 bus kan være op til 1km lang. Sensorer med RS485 grænsefladen er egnet til støjende industrielle miljøer.

Sensorer og detektorer
There are 29 products.
TST103 is a digital temperature sensor with a 1-wire interface.

Temperature sensor with Dallas chip - up to 8 pieces on the same bus
1-wire communication to the measuring electronics
With connector for cascade coupling to the next sensor
±0.5°C accuracy from -40°C to +85°C
12 bit resolution
Temperature sensor in the box
Very low power consumption
Each device has a unique 64 bit serial number

55.61 €
Item numberTST103
On the way in
TeraComm TSH206v3

1-wire communication - 2 x RJ11 connectors for daisy chain coupling.
± 3.0% relative humidity accuracy.
12 bit resolution for the moisture measurement.
14 bit resolution for temperature measurement.
calibrated digital output.
Eksellent long term stability.
Each sensor has its own unique 64-bit serial number.

111.35 €
Item numberTSH206
Physically in stock
Smoke alarm, 15m, height 11m

Smoke alarm with a diameter of 15 meters
installation up to 11 meters high
With potential-free relay contact
Smoke sensitivity: EN 54-7:2000+ A1:2002
Operating temperature: -10 to +55 °C
Dimensions: Ø100 mm, h 47 mm
Weight: 100 g

57.49 €
Item numberTSS8030R
Physically in stock
1-wire atmospheric pressure gauge, 300 - 1100HPA

1-wire barometrisk trykmåler, 2 x RJ11 til daisy chain
Relativ præcision på 0.12hPa
Høj elektromagnetisk (EMC) immunitet
Høj linearitet og nøjagtighed
Nem installation
Eksellent langtids stabilitet
Hver enhed har egen unik 64 bit serienummer

104.65 €
Item numberTSP200
Physically in stock
Temperature and humidity meter with RS485. -20 - +60°C, 10 - 95%RH. Modbus RTU

RS485 Modbus RTU combi sensor

Temperature: -20 - +60°C +/-0.6°C

Resolution: 0.1°C

Humidity: 10 - 95% rH +/- 5%

Resolution 0.1%rH

Response time: <50ms

IP54 plastic housing

Up to 32 sensors on the same RS485 bus

16 bits at temperature

12 bits when wet

Supply voltage: 4.5 - 26VDC / 25mW

Dimensions: 1054 x 68 x 35 mm

108.81 €
Item numberTSH331
Physically in stock
Temperature and humidity sensor with 1-wire. -20 - + 60 ° C, 5 - 95% RH

1-wire Combi Sensor
Temperature: -20 - +60 ° C +/- 0.6 ° C
Resolution: 0.1 ° C
Humidity (Moisture): 5 -95% Rh +/- 5%
Resolution 0.1%Rh
IP54 Plastic housing, very sturdy
Up to 8 sensors on the same 1-wire
16 bits at temperature
12 bits at moisture
Supply Voltage: 4.5 / 25mW
Dimensions: 74 x 66 x 36 mm

213.86 €
Item numberTSH230
Physically in stock
Temperature and humidity sensor with RS485, -20 to +60°C, 10-90%rH, MODBUS, cascade connection

Combi sensor for temperature and humidity measurement

Modbus RTU

2 x RJ45 connectors - with daisy chain to next module

RS485 Bus to Controller.

Up to 32 devices can be connected to the Controller

3.0% relative humidity measurement accuracy

12 bit resolution for moisture measurement

14 bit resolution for temperature measurement

With mounting flanges

Excellent long-term stability

Each module has its own ID code

123.28 €
Item numberTSH300
Physically in stock
Light sensor of visible light. 0 - 83.000lux with 23bit resolution. Automatic adjustment

1-wire lysmåler til synligt lys
0 - 83.000lux med 1 lux opløsning
Op til 23bit opløsning
Automatisk fuld skala justering
Kan kaskadekoples via RJ11 stik
Forsynes fra Controller med 5VDC/4mA
Maks. 30 meter kabel
Mål: 85 x 35 x 24 mm
IP30 plasthus med flange

114.97 €
Item numberTSL200
On the way in
TST100 - Temperature sensor with dallas chip, -40 - + 85 ° C

Temperature sensor with Dallas chip - up to 8 pieces on the same bus
1-wire communication to the measuring electronics
± 0.5 ° C accuracy from -10 ° C to + 85 ° C
12 bit resolution
Aluminum head provides low thermal resistance
IP65 close
Very low power consumption
Each unit has a unique 64 bit serial number

35.78 €
Item numberTST100
Physically in stock
Transmitter for PT100 temperature sensor - [TST200] ⇒ From -200 to + 850°C  Teracom  TST200

1-wire communication - 2 x RJ11 connectors for daisy chain connection
2 - 3 - 4 wire Pt100 temperature sensor - 4 wire is recommended.
Built-in A/D converter with compensation
24 bit resolution for temperature measurement
Calibrated digital output
Excellent long-term stability
Each sensor has its own unique 64 bit serial number

105.59 €
Item numberTST200
Physically in stock
Current loop transmitter, 0-20mA/4-20mA, 10 bit resolution with 1-wire

0-20mA 4-20mA Transmitter for 1-wire output

2 x RJ11 for daisy chaining

10-bit resolution

0-20mA and 4-20mA, 0.01mA resolution (+/-2%)

Galvanic isolation

IP30 tight

Good long-term stability

Each device has a unique 64 bit serial number

105.86 €
Item numberTSA200
Physically in stock
S0 pulse counter with MODBUS RTU, RS485, S0 Standard 62053-31

Remote data collection, remote meter monitoring, energy management

Energy meter interface module with MODBUS RTU

RS-485 interface with up to 63 devices per BUS

Built-in 120 ohm termination resistor

Flash memory for data and setup

Voltage supply from 5 to 30VDC, 50mA at 5VDC

Galvanically isolated digital inputs - 10mS polling rate

Optional inputs: Open/Closed (dry contact and 32 bit counter)

S0 pulse counter applications:

Remote monitoring of electricity meters

Industrial process control

Remote monitoring of gas meters and water meters

Monitoring of devices with S0 outputs;

Process monitoring

DIN rail mounting

Firmware update via interface.

Dimensions: 35 x 86 x 59 mm

154.23 €
Item numberTDI340
Physically in stock
Temperature sensor -20°C to +60°C. TST300

Temperature sensor TST300V2 with RS485 interface

±0.13°C accuracy from -20°C to +60°C

14-bit resolution

2 x RJ45 for daisy chain connection to next sensor

IP20 sealed enclosure

Low power consumption

Modbus address table: see TST300 manual

Log in to danbit.dk and press DOWNLOADS

MODBUS RTU interface

105.19 €
Item numberTST300
Physically in stock
TSH202v3 - 1-Wire temperature and humidity sensor from Danbit

1-wire communications - several sensors can be connected to the same unit
± 3.0% relative humidity accuracy
± 0.4% relative temperature accuracy
12 bit resolution for humidity measurement
14 bit resolution for temperature measurement
Calibrated digital output
Eksellent long-term stability
Each sensor has its own unique 64-bit serial number

87.90 €
Item numberTSH202
On the way in
85 - 250VAC detektor med Open Collector udgang, galvanisk isoleretf...

Modul til detektering af vekselspænding - 85 - 250VAC
Threshold +/-8 VAC
Galvanisk isolation mellem AC og digital output Open Collector
2 niveauer med jumper
Lav temperaturdirft
Strømforsynes fra AC siden

60.17 €
Item numberTSV100
On the way in
CO2, humidity, and temperature multi-sensor. MODBUS RTU

Multi sensor for CO2, Temperature and Humidity
Interface: RS485 - MODBUS RTU
LED indicator for status of communication
Long-term stability based on digital signal processing
Self-calibration on fresh air for CO2 measurements
Changeable communication parameters
Non-volatile memory for all settings
Firmware update via the interface
Size: 81 x 81 x 30 mm
Weight: 66g
Supply voltage: 4,5 - 26VDC / Max. 150mA

287.83 €
Item numberTSM400-4-CPTH
On the way in
Temperature and humidity sensor with a MODBUS RTU RS485 interface.

Temperature and Humidity sensor
RS485 MODBUS RTU
Temperature: +/-0,4 °C (-10 to +60°C), max. +/-0,6°C
Resolution: 0,1°C 
Humidity: +/-3,0% RH (20 - 80% RH), max. +/-5% RH
Resolution: 0,1% RH
Supply voltage: 4,5 - 26VDC
LED indicator for status of communication
Long-term stability based on digital signal processing
RS-485 interface (2-wire) carrying up to 32 nodes
Changeable bitrate and other communication parameters
Firmware update via the interface
Size: 81 x 81 x 30 mm
Weight: 66g

116.71 €
Item numberTSM400-4-TH
Physically in stock
Combined CO2 and barometric pressure sensor with a MODBUS RTU RS485 interface.

Multi sensor for CO2 and Barometric pressure
Interface: RS485 - MODBUS RTU
LED indicator for status of communication
Long-term stability based on digital signal processing
Self-calibration on fresh air for CO2 measurements
Changeable communication parameters
Non-volatile memory for all settings
Firmware update via the interface
Size: 81 x 81 x 30 mm
Weight: 66g
Supply voltage: 4,5 - 26VDC / Max. 150mA

266.53 €
Item numberTSM400-4-CP
Physically in stock
Combined CO2 and barometric pressure sensor with a 1-wire interface

Multisensor for CO2 and barometric pressure
Interface: 1-wire (+/- and data)
LED indicator for communication status
Long-term stability based on digital signal processing
Self-calibration on fresh air for CO2 measurements
Interchangeable communication parameters
Non-volatile memory for all settings
Firmware update via the interface
Size: 81 x 81 x 30 mm
Weight: 66g
Supply voltage: 4.5 - 26VDC / Max. 150mA

267.87 €
Item numberTSM400-1-CP
On the way in
Showing 1-20 of 29 item(s)