There are 48 products.
Teracom TCW181B-CM with 8 relay NO and NC contacts with up to 3Amp, either AC or DC current.

Module with password protected Web based configuration and control

1 x digital input with "dry contact" or "logic level" mode (max. 5.5VDC)

8 x relay outputs with NO/NC contacts (3Amp)

SNMP v.1 support

SNMP traps conditional alarm sending

Email transmission upon alarm

SMTP with authentication (SSL/TLS is not supported)

XML and HTTP API commands

Remote firmware update

Robust DIN-Rail/wall mounting.

Supply voltage: 10 - 14VDC


168.84 €
Item numberTCW181B-CM
Physically in stock
Data logger for temperature and humidity via Internet / LAN, SNMP v2 trap, NTP

Data logger for external temperature and humidity sensors
Sensors are not included - must be purchased separately, see selection
Memory for 70,000 measurements
Temperature, humidity and dew point can be displayed graphically
1-Wire and RS485 sensor interface
Up to 8 Teracom sensors can be connected
MODBUS TCP/IP support
SNMP v2 with trap alarm for 5 email recipients
Secure email
XML/JSON and HTTP API commands for client-server
Dynamic DNS, DynDNS, No-IP and DNS-O-Matic
NTP support for time synchronization
Remote firmware update
Supply voltage: 10 - 32VDC - purchase PSU

223.38 €
Item numberTCW210-TH
Physically in stock
Temperature and humidity sensor with 1-wire. -20 - + 60 ° C, 5 - 95% RH

1-wire Combi Sensor
Temperature: -20 - +60 ° C +/- 0.6 ° C
Resolution: 0.1 ° C
Humidity (Moisture): 5 -95% Rh +/- 5%
Resolution 0.1%Rh
IP54 Plastic housing, very sturdy
Up to 8 sensors on the same 1-wire
16 bits at temperature
12 bits at moisture
Supply Voltage: 4.5 / 25mW
Dimensions: 74 x 66 x 36 mm

213.86 €
Item numberTSH230
Physically in stock
4G LTE alarm and remote control, 2 x digital input, 2 x analog, 2 x relay output, 1-wire for sensor, MQTT

GSM/LTE alarm - 4G

Configuration via USB (Windows program) or SMS

2 x digital inputs with "dry contact" or "logic level" mode

2 x analog inputs from 0 to 60VDC, 10 bits

2 x relay outputs with NO/NC contacts

1-Wire interface for 4 Teracom temperature and humidity sensors

Input can be navigated with alarm text etc.

SMS alarm - up to 5 numbers

Email alert - up to 5 email recipients, SMTP with TLS support

1 relay can be activated with calls from up to 100 phone numbers

Push mode – XML data is sent via HTTP Post to a remote server. Response from server may contain relay setup.

MQTT 3.1.1 support

Firmware update "over the air"

Supply voltage: 8 - 28VDC, 2Watt - optional PSU

Dimensions: 109 x 65 x 32 mm

Weight: 152g

311.28 €
Item numberTCG120-4E
Physically in stock
Temperature and humidity sensor with RS485, -20 to +60°C, 10-90%rH, MODBUS, cascade connection

Combi sensor for temperature and humidity measurement

Modbus RTU

2 x RJ45 connectors - with daisy chain to next module

RS485 Bus to Controller.

Up to 32 devices can be connected to the Controller

3.0% relative humidity measurement accuracy

12 bit resolution for moisture measurement

14 bit resolution for temperature measurement

With mounting flanges

Excellent long-term stability

Each module has its own ID code

123.28 €
Item numberTSH300
Physically in stock
TCG140-4E is a 4G LTE alarm and remote control, M2M, IOT, data logger, I / O with digital and analog, relay, Modbus

Multi-band 4G LTE Cat.1 controller, logger and alarm

Setup via USB, SMS and HTTP API

USB setup - use USB cable with Mini B male

2 digital “dry contacts”. High on contact

4 analog inputs, 0 - 10VDC or 4-20mA input (10bit)

4 relay outputs, COM, NO and NC

1-Wire input for up to 8 Teracom sensors

1 x RS485 for max. 8 MODBUS RTU sensors

Data logger with 70,000 loggings

Upload data to HTTP/HTTPS Post in XML/JSON

SMS alarm and Email alarm for 5 recipients

Push mode – XML data is sent via HTTP Post to a remote server. Response from server may contain relay setup.

10 to 28VDC, 370mA @ 12VDC - optional PSU

Dimensions: 158 x 119 x 34 mm

Weight: 470g

Temperature: -20 - +55°C

386.99 €
Item numberTCG140-4E
Physically in stock
Smoke alarm, 15m, height 11m

Smoke alarm with a diameter of 15 meters
installation up to 11 meters high
With potential-free relay contact
Smoke sensitivity: EN 54-7:2000+ A1:2002
Operating temperature: -10 to +55 °C
Dimensions: Ø100 mm, h 47 mm
Weight: 100 g

57.49 €
Item numberTSS8030R
Physically in stock
Board til fjernkontrol og måling via Internet/LAN, 1 x DI, 1 x AI, ...

Open board til smart temperatur- eller fugt måling and styring
Password beskyttet Web baseret konfiguration og kontrol
1 x digital input med “dry contact” og “logic level” mode
1 x analog input fra 0 til 60VDC
1 relæ output med NO/NC kontakter
1-Wire input til 1 temperature eller fugtmåler
SNMP v.1 support
SNMP traps ved alarm
E-mail udsendelse ved alarm
SMTP med godkendelse (SSL/TLS er ikke supporteret)
HTTP og XML API kommandoer
Remote FTP firmware update.

107.87 €
Item numberTCW112-CM
Physically in stock
Temperature and humidity meter with RS485. -20 - +60°C, 10 - 95%RH. Modbus RTU

RS485 Modbus RTU combi sensor

Temperature: -20 - +60°C +/-0.6°C

Resolution: 0.1°C

Humidity: 10 - 95% rH +/- 5%

Resolution 0.1%rH

Response time: <50ms

IP54 plastic housing

Up to 32 sensors on the same RS485 bus

16 bits at temperature

12 bits when wet

Supply voltage: 4.5 - 26VDC / 25mW

Dimensions: 1054 x 68 x 35 mm

108.81 €
Item numberTSH331
Physically in stock
Light sensor of visible light. 0 - 83.000lux with 23bit resolution. Automatic adjustment

1-wire lysmåler til synligt lys
0 - 83.000lux med 1 lux opløsning
Op til 23bit opløsning
Automatisk fuld skala justering
Kan kaskadekoples via RJ11 stik
Forsynes fra Controller med 5VDC/4mA
Maks. 30 meter kabel
Mål: 85 x 35 x 24 mm
IP30 plasthus med flange

114.97 €
Item numberTSL200
On the way in
1-wire atmospheric pressure gauge, 300 - 1100HPA

1-wire barometrisk trykmåler, 2 x RJ11 til daisy chain
Relativ præcision på 0.12hPa
Høj elektromagnetisk (EMC) immunitet
Høj linearitet og nøjagtighed
Nem installation
Eksellent langtids stabilitet
Hver enhed har egen unik 64 bit serienummer

104.65 €
Item numberTSP200
Physically in stock
Current loop transmitter, 0-20mA/4-20mA, 10 bit resolution with 1-wire

0-20mA 4-20mA Transmitter for 1-wire output

2 x RJ11 for daisy chaining

10-bit resolution

0-20mA and 4-20mA, 0.01mA resolution (+/-2%)

Galvanic isolation

IP30 tight

Good long-term stability

Each device has a unique 64 bit serial number

105.86 €
Item numberTSA200
Physically in stock
TST100 - Temperature sensor with dallas chip, -40 - + 85 ° C

Temperature sensor with Dallas chip - up to 8 pieces on the same bus
1-wire communication to the measuring electronics
± 0.5 ° C accuracy from -10 ° C to + 85 ° C
12 bit resolution
Aluminum head provides low thermal resistance
IP65 close
Very low power consumption
Each unit has a unique 64 bit serial number

35.78 €
Item numberTST100
Physically in stock
S0 pulse counter with MODBUS RTU, RS485, S0 Standard 62053-31

Remote data collection, remote meter monitoring, energy management

Energy meter interface module with MODBUS RTU

RS-485 interface with up to 63 devices per BUS

Built-in 120 ohm termination resistor

Flash memory for data and setup

Voltage supply from 5 to 30VDC, 50mA at 5VDC

Galvanically isolated digital inputs - 10mS polling rate

Optional inputs: Open/Closed (dry contact and 32 bit counter)

S0 pulse counter applications:

Remote monitoring of electricity meters

Industrial process control

Remote monitoring of gas meters and water meters

Monitoring of devices with S0 outputs;

Process monitoring

DIN rail mounting

Firmware update via interface.

Dimensions: 35 x 86 x 59 mm

154.23 €
Item numberTDI340
Physically in stock
Ethernet-based output module for current, voltage and kontakt.- Teracom TCW280

Multi output module for networks with galvanic I/O

10/100 Mbit Ethernet connection

Password-protected WEB server

2 analog outputs with voltage and current generator

0 - 20mA, 4 - 20mA, 0 - 24mA

0 - 5V or 0 - 10V voltage output

12-bit resolution

4 digital (open Drain) outputs with ON/OFF or PWM

2 relays with COM, NO and NC contacts

4 scheduled actions, once or weekly

Supports NTP

SNMP v2, SNMP trap for up to 5 recipients

MODBUS TCP/IP

HTTP upload with current status in XML or JSON file to remote server

HTTP API commands in server and client mode

HTTP Post can be sent to 3 servers

DIN rail/wall mounting

10 - 28VDC/ max. 250mA - optional PSU

436.71 €
Item numberTCW280
Physically in stock
Transmitter for PT100 temperature sensor - [TST200] ⇒ From -200 to + 850°C  Teracom  TST200

1-wire communication - 2 x RJ11 connectors for daisy chain connection
2 - 3 - 4 wire Pt100 temperature sensor - 4 wire is recommended.
Built-in A/D converter with compensation
24 bit resolution for temperature measurement
Calibrated digital output
Excellent long-term stability
Each sensor has its own unique 64 bit serial number

105.59 €
Item numberTST200
Physically in stock
Energy meter with 24 galvalically isolated I/O, RS-485, Digital and analog inputs

Multi input Data logger for up to 70000 loggings

10/100 Mbit Ethernet

Password-protected, web-based configuration and control

4 digital inputs, compatible with S0 pulse interface

6 analog inputs with 0/10V and 0/20mA

MODBUS RTU interface for up to 24 sensors (registers)

Up to 24 channels for monitoring

Up to 24 independent alarms

SNMP v.2 support - SNMP Trap - alarm notifications

HTTP and SNMP port change - HTTP API commands

Periodic HTTP posting of XML/JSON status files to client-server systems

MODBUS TCP/IP support

Dynamic DNS with DynDNS, No-IP and DNS-O-Matic support

NTP protocol support

Supply voltage: 10 to 28V DC

392.62 €
Item numberTCW260
Physically in stock
Teracom monitor- og datalogger program, licens til 11 - 100 enheder...

DAQ software til TERACOM Ethernet baserede måleenheder
Brugervenlig WEB interface for nem konfigurering og kontrol
Fleksible bruger adgang og management
Distribueret monitorering af måleenheder i “client” mode
Alarm advisering
Aktivitets log
Grafisk og data visning med stor visualisering
Nem adgang til rå-data, tabeller, eksport in .csv format (kommasepareret)
Database management
Sende kommando til kontrollere in “server” og “client” mode
Kommando status log

767.95 €
Item numberTC-MONITOR-100
On the way in
TCW122B-WD digital I/O and analog over ethernet measurement over the internet

Module with password protected Web based configuration and control

Instant ICMP watchdog - no echo will restart the module

1-Wire interface for 2 sensors

2 x relay outputs with NO/NC contacts

2 x analog input 0 to 60VDC - 10bit resolution, 100mV display

2 x digital input with "dry contact" or "logic level" mode

Stable IP watchdog monitoring - for equipment restart

SNMP v.1 support

SNMP trap conditional messages

VLAN and MAC address filtering

Remote FTP firmware update.

Supply voltage: 10 - 14VDC - purchase PSU

144.99 €
Item numberTCW122B-WD
Physically in stock
TCW241 - Data Collector and Remote Control Module with Web Interface - Simple Configuration

Web based Data Collector module with built-in WebServer

4 x digital input Dry - external contact without voltage

4 x analog inputs with 0 to 60VDC - 10mV resolution

Multiply and offset for analog inputs and sensors

1-Wire for max. 8 sensors (16 parameters)

4 x powerful relay outputs with NO/NC contacts

MODBUS TCP/IP support

SNMP v2 support with trap alarm for 5 recipients

4 schemes for real-time control of relays

Specific logic functions for relays

Secure email

XML/JSON and HTTP API commands for client-server

Dynamic DNS support for DynDNS, No-IP and DNS-O-Matic

NTP time sync

Supply voltage: 10 - 28VDC - purchase PSU

Dimensions: 145 x 90 x 40 mm

293.19 €
Item numberTCW241
On the way in
Showing 1-20 of 48 item(s)