Item number DB15M-TERM

Breakout Board Terminal Adaptor, D-Sub 15-Pin Male, 16-Contact Terminal Block, -40 to 85°C

D-Sub 15-pin male connector
16-contact screw terminal block
Terminals 1-15 wired to D-Sub 1-15
SHL terminal connected to D-Sub shell
Rated 30VDC, 0.5A
Contact resistance: 30mOhm max.
Insulation res. min. 100mOhm/500VDC
Terminal pitch: 3.81 mm
Operating temp: -40 to 85C
50.5 x 39.5 x 13.35 mm

26.26 €
Excl. VAT
Quantity
Physically in stock
file_download DOWNLOADS

Specifications

Operating Temp. -40°C to +85°C
Interface D-Sub 15-pin, male
Dimensioner 50.5 x 39.5 x 13.35 mm (overall length x PCB width x depth); D-Sub flange 39.14 mm, D-Sub mounting distance 33.32 mm, secondary length 44.7 mm, terminal block width 15.1 mm
Pin Assignment Terminals 1-15 connected 1:1 to D-Sub pins 1-15; SHL terminal connected to D-Sub shell
Rated Current 0.5 A
Number of terminals 16-pole screw terminal block
Rated voltage 30 VDC
Contact resistance Max. 30 mΩ
Insulation resistance Min. 100 mΩ at 500 VDC

D-Sub 15-Pin Male Breakout Board with Screw Terminals

This breakout board terminal adaptor brings a 15-pin male D-Sub connector out to a 16-contact screw terminal block. It lets engineers and system integrators wire, test or prototype D-Sub signals without soldering or building a custom cable.

One-to-One Pin Mapping with a Shell Terminal

Terminals 1 to 15 are wired directly to D-Sub pins 1 to 15, so the wiring follows the connector pinout and needs no cross-reference table. The sixteenth terminal, marked SHL, is connected to the D-Sub shell. This allows cable shielding to be terminated or grounded at the same terminal block.

Suited to Signal and Low-Power Wiring

The ratings of 30VDC and 0.5A fit signal and control lines rather than power distribution. The operating range of -40° to 85°C allows use in cold or warm installation environments.