Item number DOOR-MAGNET-DUAL8
Double electronic door magnet for 12 / 24VDC with automatic switching. Holding force up to 2 x 364 kg, for indoors double-doors
Electronic door magnet for double-doors, folding door etc.
Holding force up to 364 kg for each door
Aluminum housing and vandal proof
Supply voltage for team: 12VDC or 24VDC, minimum 2 x 6Watt
Automatic change-over between 12 and 24 VDC
No holding force when not energized
Operating temperature: -10 - 55 ° C
Humidity: 0-95% non-condensing
Double magnet: 530 x 49 x 29 mm
Door plates: 185 x 45 x 14 mm
Double-mounting plate: 530 x 29 x 5.5 mm
Weight: ca. 5.6 kg
416.34 €
Excl. VAT
Quantity
Physically in stock
Specifications
| Operating Temp. | -10 - +55°C |
|---|---|
| Effekt | Minimum 2 x 6Watt. Strømforsyning bør være overdimensioneret |
| Forsyning | 12/24VDC med automatisk omskiftning |
| Luftfugtighed | 0 - 95% RH (ikke kondenserende) |
| Compositions | Aluminium med epoxy forsegling |
| Weight | ca. 5,6 kg |
| Dimensioner | 530 x 49 x 29 mm |
DOOR-MAGNET-DUAL8 used for wing doors, swing doors, double doors o.li. where there can be installed an electronic lock plates. DOOR-MAGNET-DUAL8 can be used with most access control systems that have single or dual relay output. The product contains 2 powerful electro-magnets, which "locks" the stuck to the piece of metal which is mounted on the respective door. When there is voltage on DOOR magnet DUAL8, the door can not be opened. An access control connected to DOOR-MAGNET-DUAL8 who accept such. a password that will interrupt the voltage to the magnet coil and the magnets release so that the doors can be opened. Holding Force: 2 x 364 kg. Automatic switching between 12VDC and 24VDC voltage to hold the magnet. Estimated power consumption is minimum 12Watt. When the electromagnets are supplied with voltage in hold mode, the power supplies for DOOR-MAGNET-DUAL8 deliver at least double its power (25 - 50Watt), this in order to minimize heat generation in the power supply.
Rev: LO
24VDC 1.7A (40Watt) power supply from 100-240VAC, DIN rail
AC / DC power supply for DIN rail mounting
100-240V AC, 50 / 60Hz, 1.1A
Output, 24V, 1.7A (40 Watt)
Screw terminal
Adjustable output voltage
Short-circuit, overload and surge protection
Compact dimensions: 40 x 100 x 90 mm
Working temperature: -20-70 ° C
44.89 €
Item number:DC24V1.7A-D
Access control door opening via mobile phone Bluetooth, RFID reader and PIN. With the event logs
Bluetooth BLE 4.2 (Low Energy)
Up to 200 user
With user rights
Up to 1000 event logs in memory
access with RFID tag (EM, 125kHz)
access by PIN code (4-8 digits)
with keypad backlighting
app for the iPhone and Android
Range up to 50 meters
Can be set to open at pressures in the APP or automatically once inside the selected range
With solid state relay - no wear
With vandal alarm
Supply voltage: 12 to 24VDC
Dimensions: 152 x 45 x 23 mm
280.06 €
Item number:ADGANG-BT-RFIDKEY
Access control for controlling the electronic door lock via the mobile phone Android APP, Bluetooth
Bluetooth
Up to 196 users
APP for Android - e-access E1196
Range up to 50 meters
Can be set to open by pressing in the APP
Can be set to open automatically when you are within range
Built-in buzzer 85dBA can be activated when the door is open.
When you choose to activate Bi-stable function, you can press down the E button on the screen for a few seconds to activate and keep the door unlocked indefinitely.
Does not save events (no log function)
132.66 €
Item number:ADGANG-BT
Outdoor keypad with RFID/fob reader. Stand-alone access control. 125kHz EM standard 12 - 24VDC
Stand-alone access control in IP68 sealed enclosure
ADGANG20-RFID is a stand-alone access controller that can control an electronic door lock.
Identification: Via keypad or RFID EM card/fob.
User capacity: Max. 2000 users.
Identification time: < 20 ms.
RFID reader: EM type for 125 kHz.
Vandal alarm if the housing is damaged
Relay output with normally open and normally closed function 12VDC or 24VDC / 6Watt
Enclosure: IP68 sealed stainless steel metal enclosure
Technically demanding product - support hours can be purchased as an add-on
101.17 €
Item number:ADGANG20-RFID
Stand-alone access control in IP68 sealed metal enclosure, Mifare at 13.56 MHz
Stand-alone access controller Mifare RFID
Red, yellow and green LED for status indication
Identification: Via keypad or Mifare RFID card.
User capacity: Max. 2000 users.
Identification time: < 20 ms.
RFID reader: Mifare at 13.56 MHz.
Door lock control: Relay output with make and break function, max. 12 Volt / 0.5A.
Enclosure: IP68 sealed stainless steel metal enclosure
Vandal alarm if the housing is destroyed
Technically demanding product - Support hours can be purchased as an add-on
159.73 €
Item number:ADGANG20-RFID-M
Other products in the same category:
Waterproof electronic door magnet, 12VDC. Stainless steel house. Holding force up to 136 kg
The door magnet with holding force up to 136 kg
stainless steel housing full sealed with epoxy
Voltage for holding: 12VDC 6 Watt
No holding force at voltageless
Operating temperature: -10 to +55°C
Magnet: 170 x 32 x 24 mm
Amaturple plate: 152 x 32 x 10 mm
Anti magnetic function
Weight: Approx. 2.5 kg
173.26 €
Item number:DOOR-MAGNET-170U
Waterproof electronic door magnet, 12 / 24VDC switching. Stainless steel, 100% sealed. Holding force up to 363 kg
The door magnet with holding force up to 363 kg
Rust free steel cabinet full sealed with epoxy and is vandal safe
Voltage for hold: 12VDC or 24VDC, 6 Watt
Switch between 12 and 24VDC
No holding force at no voltage
Operating temperature: -10 to + 55 ° C
Magnet: 216 x 53 x 32 mm
Amaturple plate: 185 x 45 x 14 mm
anti magnetic function
Weight: Approx. 4.5 kg
240.13 €
Item number:DOOR-MAGNET-V8
Electronic lock, for mounting on cupboards and doors, holding force approx. 100kg, 12-28VDC
Compact motorized lock with separate pawl
Locked without tension
Releases the locking pawl in case of short-term tension
The pal part has a push-out (5-8mm)
Adjustable delay on relocking 2 to 5 seconds
2 lock inputs
Can be mounted in 2 different ways
Control voltage - 12 - 28VDC / VAC, max. 165mA
Dimensions: 60 x 60 x 22mm
110.82 €
Item number:LOCK-CAB12-28V100
Waterproof electronic door magnet, holding force 545 kg, 12 / 24VDC / 6 Watt. Bond-sensor Stainless steel, 100% sealed
door magnet with clamping force up to 545kg
Rusrfri steel cabinet full sealed with epoxy and is vandal proof
Equipped with thread for flexible tube to protect the cable
Supply voltage for team: 12VDC or 24VDC, 6Watt
Cable change-over between 12 and 24 VDC
Only holding force when energized
With Bond Sensor (Lock indicator)
Operating temperature: -10 to + 55°C
Magnetic: 220 x 62 x 41 mm
Door-plate: 185 x 61 x 16 mm
Anti-magnetic feature
Weight: ca. 5 kg
208.64 €
Item number:DOOR-MAGNET-V12
Mounting bracket for DOOR-MAGNET-V8 for outward-facing door. Extruded aluminium. L-bracket.
Mounting angle for DOOR-MAGNET-V8 for outward-facing door. The angle clamp is mounted on the lower edge of the door frame.
It is very important that the anchor plate is mounted floating suspended and that it can come into 100% contact with the holding magnet.
47.70 €
Item number:DOOR-BRACKET-L400
Electronic strike for door frame. 38 mm monitor function. 12VDC 300mA. Holding force of 450kg.
Electric strike for door frame, with lock monitor, 38 mm
with lock open without excitement
with lock closed without excitement
Force: 450kg
Voltage: 12VDC 300mA polarity independent
Lock Monitor: COM, NC NO output
Buy: DC12V/1A-R-Q
Dim: 202 x 36.5 x 27 mm
93.67 €
Item number:DOORLOCK38M
















